Your Cart is Empty
DEG-Cut-Out
$99.00
These exhaust cut outs allow you to run your exhaust through the factory trailing arm crossmember. They come with all hardware and a template. Sold as a PAIR.
Notes:
Works with stock trailing arm crossmember.
Inside diameter of pass through is 3.5".
Works perfect to tuck the exhaust up in the frame rails.
Perfect fit!
These worked perfect. I wish I could get a v-band flange for a 3" exhaust through the opening, but not more room left in the x-member to make the opening much bigger.
This is a quality product.
I did have to drill two additional holes in the center of the template. I used the holes for bolts and nuts to hold the center in place when drilling out the center hole.
I ended up using a 4 1/4 hole saw that I purchased from Harbor Fright
No problems with the extra bolts in the middle holding the center together when drilling.
These cut outs are really nicely made. The welds are a stack of dimes!
