8012380-01-01

Unisteer Power Rack & Pinion Kit - 73-87 C10

On this kit we used a traditional style rear steer rack & pinion that is mounted to a one piece bracket which bolts up to the outside of either frame rail in the same holes as the original steering box and idler arms. This kit is for rear wheel drive vehicles only, NOT 4x4s. Installs have been done on V-8s, so there should be room if using a 6 Cylinder. There is quite a bit of room for the shaft support, but some headers may require modification. A two groove pulley on your water pump is required for this kit.

Includes:
  • Rack and Pinion
  • Outer Tie Rod Ends
  • Mounting Bracket
  • Pump Kit
  • Steering Shaft Kit
  • Mounting Hardware
Tech Info:
  • 3/4-36 Spline
  • 5.75" Travel
  • 2-7/8 Turn from Lock-To-Lock
  • #6 Pressure Port (Upper)
  • #6 Return Port (Lower)
  • Inner End Threads - M14x1.5
  • Uses Factory Outer Ends